Chemlease 2710 Release Agent is a solvent‑based, semi‑permanent release for the composites industry, designed for easy one‑step application. Apply a very light coat and allow it to dry, mould finish is reproduced once dry. After cleaning and final wipe-down, apply 4–6 coats with 15‑minute cure between coats, then cure 30 minutes before moulding. Touch up with 1+ coats as needed.
Chemlease 2710 Release Agent is intended for composites moulding where a solvent-based semi-permanent release film is required with a simple, one-step application method. Apply the product very lightly and allow it to dry. The original mould surface finish appearance is reproduced once dry, which supports surface-quality moulding workflows. For best results, prepare the mould by thoroughly removing wax, oils, sealers, buffing compounds and other release residues – often requiring abrasive methods – then perform a final clean using an appropriate Chemlease® mould cleaner. Apply a Chemlease® sealer where appropriate. Apply via wipe-on or HVLP spray, building 4–6 coats with 15 minutes cure between coats and a minimum 30 minutes cure after the final coat before moulding. For ongoing production, apply one or more touch-up coats when release becomes difficult, allow 15 minutes cure, and resume moulding. Store below 49°C, keep containers tightly sealed, and never puncture containers.
|
FEATURE
|
DESCRIPTION
|
|---|---|
|
One‑step application (apply lightly, let dry)
|
Designed for easy one‑step application—apply to the mould surface very lightly and allow to dry, with the original mould surface appearance reproduced once dry.
|
|
Predictable, repeatable coating build
|
Typical application guidance is 4–6 coats with 15 minutes cure between coats and 30 minutes final cure before moulding, supporting consistent film build and repeatability.
|
|
Flexible application methods (wipe or spray)
|
Can be applied by wipe-on (lightly dampened cotton cloth) or via HVLP spray, supporting different shop workflows.
|
|
Supports tooling and process conditioning
|
Mould preparation guidance emphasises thorough cleaning (including removal of wax/oils/sealers/buffing compounds and other releases) and a final clean with an appropriate Chemlease® mould cleaner; sealing is used when appropriate.
|
|
Practical touch-up maintenance
|
When release becomes difficult, you can reapply one or more coats, cure 15 minutes, and resume moulding, helping maintain uptime without full strip-down.
|
This product is available in a variety of packaging sizes. Please contact our customer support team for details.
