GRP and FRP composites are used extensively in UK construction – from architectural cladding and rooflight panels to drainage channels, bridge decking and utility covers. MVP UK & Ireland supplies the spray, lamination and mould release equipment for the full range of construction composite products.
Architectural cladding and rainscreen panels
Rooflights and translucent sheeting
Drainage channels, gullies and covers
Bridge decking and structural profiles
Utility and access covers
Architectural feature mouldings
Construction composites span a wide range of products – from high-volume drainage components to bespoke architectural mouldings. Equipment requirements vary accordingly, from continuous production spray systems to small-batch hand lay-up for complex profiles.
Chopper and wet-out systems for high-volume production of architectural cladding panels, rainscreen units and facade elements.
Spray lamination equipment for GRP drainage channels, gullies, inspection covers and utility products.
Injection and closed mould equipment for structural FRP profiles, bridge deck panels and load-bearing composite components.
Gelcoat and lamination equipment for bespoke architectural cornices, columns, pediments and decorative mouldings.
On-site
All equipment commissioned and trained at your facility
UK & IE
Full coverage of Great Britain and Ireland
0
Solvent emissions with water-based release agent range
Lifetime
Technical support for the working life of equipment supplied
Need process advice? MVP UK & Ireland has direct composite manufacturing experience alongside our equipment knowledge. We can discuss your specific process, resin system and production requirements before recommending equipment or release chemistry.
High-throughput spray lamination for drainage products, cladding panels, and construction composite sheets.
Pigmented gelcoat application for architectural panels and mouldings requiring durable exterior finishes.
Closed mould production of structural construction components 0 RTM and LRM for repeatable geometry.
Chemlease® and Zyvax® systems for construction composite tooling, including semi-permanent grades for high-volume production.
Acetone and solvent recovery for facilities producing drainage products and construction composites at scale.
Hand-held applicators for architectural moulding production, bespoke components and quality finishing work.
“Construction composite manufacturers need reliable, repeatable production. The equipment and release chemistry we supply is designed for exactly that – consistent output across high-volume or complex-geometry tooling.”
MVP UK & Ireland – Technical Team
High-volume production of drainage and utility products demands consistent spray output and fast cycle times
Architectural panels require gelcoat surface quality meeting specification finish standards
Semi-permanent release agents reduce downtime on high-cycle drainage and panel moulds
Structural components for infrastructure require controlled laminate thickness and fibre fraction
VOC and solvent management is increasingly regulated on construction manufacturing sites
Answers to the questions we receive most often from construction composite manufacturers about equipment, release agents and process support.
GRP cladding and architectural panel production typically uses chopper and wet-out systems for spray-up lamination and gelcoat spray systems for exterior finish coats. MVP UK & Ireland supplies the full range of spray lamination equipment, along with mould release agents suited to panel production tooling.
Semi-permanent mould release agents are particularly relevant for high-volume construction composite production, as they reduce the frequency of reapplication on drainage, panel and utility product moulds. MVP UK & Ireland supplies both Chemlease® PMR and Zyvax® Flex-Z grades, with selection advice based on resin system and mould cycle rate.
Yes. MVP UK & Ireland supplies chopper and wet-out systems for high-throughput spray lamination of FRP drainage channels, gullies, manhole covers and utility products. Release agent and solvent recovery equipment are also supplied for complete process support.
Yes. MVP UK & Ireland supplies injection systems for RTM and LRTM closed mould production of structural FRP components used in bridge decking, infrastructure and construction applications requiring controlled fibre fraction and laminate geometry.
Contact MVP UK & Ireland for equipment selection, release agent advice or technical support for your construction composites operation.